| 引用本文： |
-
张同双,钟德安,潘 良,等.基于星敏感器指向的船载雷达轴系误差分离模型[J].电讯技术，2015，55（5）： - . [点击复制]
- ZHANG Tongshuang,ZHONG Dean,PAN Liang,et al.Error separation model for shaft parameters of ship-borne radar based on pointing of star sensor[J].，2015，55（5）： - . [点击复制]
|
|
| 摘要: |
| 针对现有船载雷达动态标校方法的不足,提出了一种基于星敏感器的船载雷达轴系误差标校方法。该方法以精确的星敏感器地平指向为比对基准,解算船载雷达的轴系误差。设计了基于星敏感器的船载雷达动态标校方案,分析了船摇测量误差对雷达测角精度的影响,推导了天线座垂向变形引起的雷达测角误差修正模型。根据测量目标的不同,分别建立了联合测星与跟踪目标时的船载雷达轴系误差分离模型。最后通过联合测星试验对轴系误差分离模型进行了验证。试验结果表明,利用动态标校成果修正后的船载雷达方位、俯仰系统残差分别为3″和9″,随机残差分别为40″和45″,满足雷达轴系误差标定要求,具有较高的实用价值。 |
| 关键词: 船载雷达 星敏感器 轴系误差 动态标定 误差分离 |
| DOI： |
|
| 基金项目: |
|
| Error separation model for shaft parameters of ship-borne radar based on pointing of star sensor |
| ZHANG Tongshuang,ZHONG Dean,PAN Liang,JIAO Hongwei,WANG Erjian |
| () |
| Abstract: |
| In view of the deficiency of existing dynamic calibration methods for ship-borne radar,a shaft parameter calibration method for ship-borne radar based on star sensor is proposed. This method calculates the shaft parameters of ship-borne radar by taking the precise horizontal orientation of star sensor as comparison basis. A dynamic calibration scheme of ship-borne radar based on star sensor is designed,the influence of ship swing measurement error on radar angle measurement precision is analyzed and the angle measurement error correction model of radar antenna pedestal deformation is derived. According to the different measuring targets,the error separation models for shaft parameters of ship-borne radar in joint measuring star and tracking target are founded respectively. By the experiment of joint measuring star,the error separation model for shaft parameters is verified. Experimental results show that,by using the dynamic calibration results,the rectified system residuals of ship-borne radar azimuth angle and pitch angle are 3″ and 9″,the random errors are 40″ and 45″,respectively. The results meet the technical requirements and the model is valuable in practice engineering applications. |
| Key words: ship-borne radar star sensor shaft parameter dynamic calibration error separation |
《电讯技术》编辑部 